Technician Exam T5: Electrical Principles Questions and Answers

At a glance

  • Questions in this section of the pool: 50
  • Questions from this section on your exam: 4 of 35, one from each group
  • Free on this page: group T5A, 11 questions with answers
  • Pool in use: 2026 to 2030 (exams given July 1, 2026 through June 30, 2030)

Subelement T5 of the Technician exam covers basic electricity: current, voltage, resistance and power, metric prefixes, decibels, and Ohm’s Law. The questions below are from the official question pool, and the questions on your exam will be worded exactly as they are here. The order of the four choices can change, so learn the answer itself and not its letter.

What this section covers

  • T5A: Current and voltage: terminology and units, conductors and insulators, alternating and direct current (11 questions, free below)
  • T5B: Math for electronics: conversion of electrical units, decibels (13 questions, full binder)
  • T5C: Capacitance and inductance terminology and units; Radio frequency definition and units; Impedance definition and units; Calculating power (12 questions, full binder)
  • T5D: Ohm’s Law; Series and parallel circuits (14 questions, full binder)

Free sample: group T5A

Current and voltage: terminology and units, conductors and insulators, alternating and direct current. One question on your exam comes from this group. The correct answer is highlighted.

T5A01

Electrical current is measured in which of the following units?

  1. Volts
  2. Watts
  3. Ohms
  4. Amperes

Correct answer: D. Amperes

Why: Current is measured in amperes, often shortened to amps. Volts measure voltage, watts measure power and ohms measure resistance.

T5A02

Electrical power is measured in which of the following units?

  1. Volts
  2. Watts
  3. Watt-hours
  4. Amperes

Correct answer: B. Watts

Why: Power is measured in watts. A watt-hour is a unit of energy, which is power used over time.

T5A03

What is the term for the flow of electrons in an electric circuit?

  1. Voltage
  2. Amperes per second
  3. Volts per second
  4. Current

Correct answer: D. Current

Why: Current is the flow of electrons through a circuit.

T5A04

What term describes the number of times per second that an alternating current makes a complete cycle?

  1. Pulse rate
  2. Wave number
  3. Frequency
  4. Wavelength

Correct answer: C. Frequency

Why: Frequency is the number of complete cycles an alternating current makes each second.

T5A05

A difference in which of the following causes electron flow?

  1. Voltage
  2. Ampere-hours
  3. Capacitance
  4. Inductance

Correct answer: A. Voltage

Why: Voltage is the electrical pressure that pushes electrons through a circuit. Without a difference in voltage, no current flows.

T5A06

What is the unit of frequency?

  1. Hertz
  2. Henry
  3. Farad
  4. Epicycles per second

Correct answer: A. Hertz

Why: Frequency is measured in hertz. One hertz is one cycle per second.

T5A07

Why are metals generally good conductors of electricity?

  1. They have relatively high density
  2. They have many free electrons
  3. They have many free protons
  4. They have relatively high Young’s modulus values

Correct answer: B. They have many free electrons

Why: Metals conduct well because they have many free electrons that can move from atom to atom.

T5A08

Which of the following is a good electrical insulator?

  1. Sea water
  2. Glass
  3. Stainless steel
  4. Graphite

Correct answer: B. Glass

Why: Glass is a good insulator. Sea water, stainless steel and graphite all conduct electricity.

T5A09

Which of the following describes alternating current?

  1. Current that alternates between a positive direction and zero
  2. Current that alternates between a negative direction and zero
  3. Current that alternates between positive and negative directions
  4. All these answers are correct

Correct answer: C. Current that alternates between positive and negative directions

Why: Alternating current reverses direction, flowing one way and then the other. Direct current flows one way only.

T5A10

Which term describes the rate at which electrical energy is used?

  1. Resistance
  2. Current
  3. Power
  4. Voltage

Correct answer: C. Power

Why: Power is the rate at which electrical energy is used.

T5A11

What type of current flow is opposed by resistance?

  1. Direct current
  2. Alternating current
  3. RF current
  4. All these choices are correct

Correct answer: D. All these choices are correct

Why: Resistance opposes every kind of current: direct, alternating and radio frequency.

The other 3 groups in this section

These 39 questions are worth 3 of the 4 points this section carries on your exam.

T5B

Math for electronics: conversion of electrical units, decibels

13 questions, in the full binder

T5C

Capacitance and inductance terminology and units; Radio frequency definition and units; Impedance definition and units; Calculating power

12 questions, in the full binder

T5D

Ohm’s Law; Series and parallel circuits

14 questions, in the full binder

The full Technician binder

Get the other 39 questions in T5, with explanations

  • All 409 official questions, every group in every section
  • A plain-English explanation under each answer
  • Unlimited full-length 35-question practice tests
  • A printable binder you can study from offline

Get the full binder

Keep going

See the Technician exam study guide for how the exam is scored, or try the free 10-question sample test.

Source: NCVEC Question Pool Committee, 2026 to 2030 Technician Class (Element 2) question pool, public release of February 19, 2026. Test Day Binder is not affiliated with the FCC, the NCVEC, or any volunteer examiner group.

Last checked: November 2026.

Leave a Comment