At a glance
- Questions in this section of the pool: 47
- Questions from this section on your exam: 4 of 35, one from each group
- Free on this page: group T8A, 12 questions with answers
- Pool in use: 2026 to 2030 (exams given July 1, 2026 through June 30, 2030)
Subelement T8 of the Technician exam covers the ways a signal can carry information: FM, single sideband, digital modes, satellites, and other specialized operating. The questions below are from the official question pool, and the questions on your exam will be worded exactly as they are here. The order of the four choices can change, so learn the answer itself and not its letter.
What this section covers
- T8A: Basic characteristics of FM and SSB; Bandwidth of various modulation modes: CW, SSB, FM, fast-scan TV; Choice of emission type: selection of USB vs LSB, use of SSB for weak signal work, use of FM for VHF packet and repeaters (12 questions, free below)
- T8B: Amateur satellite operation: Doppler shift, basic orbits, operating protocols, modulation mode selection, transmitter power considerations, telemetry, satellite tracking programs, beacons, uplink and downlink mode definitions, spin fading, definition of “LEO”, setting uplink power (12 questions, full binder)
- T8C: Operating activities: radio direction finding, contests, linking over the internet, exchanging grid locators (11 questions, full binder)
- T8D: Non-voice and digital communications: image signals and definition of NTSC, CW, packet radio, PSK, APRS, error detection and correction, amateur radio networking, DMR, WSJT modes, Broadband-Hamnet (12 questions, full binder)
Free sample: group T8A
Basic characteristics of FM and SSB; Bandwidth of various modulation modes: CW, SSB, FM, fast-scan TV; Choice of emission type: selection of USB vs LSB, use of SSB for weak signal work, use of FM for VHF packet and repeaters. One question on your exam comes from this group. The correct answer is highlighted.
T8A01
Which of the following is a form of amplitude modulation?
- Spread spectrum
- Packet radio
- Single sideband
- Phase shift keying (PSK)
Correct answer: C. Single sideband
Why: Single sideband is a form of amplitude modulation in which the carrier and one sideband are removed.
T8A02
What type of modulation is commonly used for VHF packet radio transmissions?
- FM or PM
- SSB
- AM
- PSK
Correct answer: A. FM or PM
Why: VHF packet radio is normally sent using FM or phase modulation (PM).
T8A03
Which type of voice mode is often used for long-distance (weak signal) contacts on the VHF and UHF bands?
- FM
- DRM
- SSB
- PM
Correct answer: C. SSB
Why: Single sideband is used for long-distance, weak-signal voice contacts on VHF and UHF because it is narrow and efficient.
T8A04
Which type of modulation is commonly used for VHF and UHF voice repeaters?
- AM
- SSB
- PSK
- FM or PM
Correct answer: D. FM or PM
Why: Voice repeaters on VHF and UHF use FM or phase modulation (PM).
T8A05
Which of the following signal types has the narrowest bandwidth?
- FM voice
- SSB voice
- CW
- Slow-scan TV
Correct answer: C. CW
Why: CW, which is Morse code, has the narrowest bandwidth of the choices.
T8A06
Which sideband is normally used for 10-meter HF, VHF, and UHF single-sideband communications?
- Upper sideband
- Lower sideband
- Suppressed sideband
- Inverted sideband
Correct answer: A. Upper sideband
Why: Upper sideband is the convention on 10 meters and on all VHF and UHF bands.
T8A07
What is one characteristic of single sideband (SSB) compared to FM?
- SSB signals are easier to tune in correctly
- SSB signals are less susceptible to interference
- SSB signals have narrower bandwidth
- SSB signals are less susceptible to high SWR
Correct answer: C. SSB signals have narrower bandwidth
Why: A single-sideband signal is much narrower than an FM signal, about 3 kHz compared with 10 to 15 kHz.
T8A08
What is the approximate bandwidth of a typical single sideband (SSB) voice signal?
- 1 kHz
- 3 kHz
- 6 kHz
- 15 kHz
Correct answer: B. 3 kHz
Why: A single-sideband voice signal is about 3 kHz wide.
T8A09
What is the approximate bandwidth of an FM voice signal on VHF repeaters?
- Less than 500 Hz
- About 150 kHz
- Between 10 and 15 kHz
- Between 50 and 125 kHz
Correct answer: C. Between 10 and 15 kHz
Why: An FM voice signal on a VHF repeater is between 10 and 15 kHz wide.
T8A10
What is the approximate bandwidth of AM fast-scan TV transmissions?
- More than 10 MHz
- About 6 MHz
- About 3 MHz
- About 1 MHz
Correct answer: B. About 6 MHz
Why: Fast-scan amateur TV using AM takes about 6 MHz, like an old analog broadcast TV channel.
T8A11
What is the approximate bandwidth required to transmit a CW signal?
- 2.4 kHz
- 150 Hz
- 1000 Hz
- 15 kHz
Correct answer: B. 150 Hz
Why: A CW signal needs only about 150 Hz.
T8A12
Which of the following is a disadvantage of FM compared with single sideband?
- Voice quality is poorer
- Only one signal can be received at a time
- FM signals are harder to tune
- FM signals are more susceptible to high SWR
Correct answer: B. Only one signal can be received at a time
Why: An FM receiver locks onto the strongest signal and suppresses the others, so only one signal can be heard at a time. This is called the capture effect.
The other 3 groups in this section
These 35 questions are worth 3 of the 4 points this section carries on your exam.
T8B
Amateur satellite operation: Doppler shift, basic orbits, operating protocols, modulation mode selection, transmitter power considerations, telemetry, satellite tracking programs, beacons, uplink and downlink mode definitions, spin fading, definition of “LEO”, setting uplink power
12 questions, in the full binder
T8C
Operating activities: radio direction finding, contests, linking over the internet, exchanging grid locators
11 questions, in the full binder
T8D
Non-voice and digital communications: image signals and definition of NTSC, CW, packet radio, PSK, APRS, error detection and correction, amateur radio networking, DMR, WSJT modes, Broadband-Hamnet
12 questions, in the full binder
The full Technician binder
Get the other 35 questions in T8, with explanations
- All 409 official questions, every group in every section
- A plain-English explanation under each answer
- Unlimited full-length 35-question practice tests
- A printable binder you can study from offline
Keep going
See the Technician exam study guide for how the exam is scored, or try the free 10-question sample test.
Source: NCVEC Question Pool Committee, 2026 to 2030 Technician Class (Element 2) question pool, public release of February 19, 2026. Test Day Binder is not affiliated with the FCC, the NCVEC, or any volunteer examiner group.
Last checked: November 2026.