Technician Exam T3: Radio Wave Propagation Questions and Answers

At a glance

  • Questions in this section of the pool: 35
  • Questions from this section on your exam: 3 of 35, one from each group
  • Free on this page: group T3A, 12 questions with answers
  • Pool in use: 2026 to 2030 (exams given July 1, 2026 through June 30, 2030)

Subelement T3 of the Technician exam covers how radio signals travel: wavelength and frequency, fading and multipath, and the propagation modes a Technician is likely to meet. The questions below are from the official question pool, and the questions on your exam will be worded exactly as they are here. The order of the four choices can change, so learn the answer itself and not its letter.

What this section covers

  • T3A: Radio wave characteristics: how a radio signal travels, fading, multipath, polarization, wavelength vs absorption; Antenna orientation (12 questions, free below)
  • T3B: Electromagnetic wave properties: wavelength vs frequency, nature and velocity of electromagnetic waves, relationship of wavelength and frequency; Electromagnetic Spectrum Definitions: UHF, VHF, HF (12 questions, full binder)
  • T3C: Propagation modes: sporadic E, meteor scatter, auroral propagation, tropospheric ducting; F region skip; Line of sight and radio horizon (11 questions, full binder)

Free sample: group T3A

Radio wave characteristics: how a radio signal travels, fading, multipath, polarization, wavelength vs absorption; Antenna orientation. One question on your exam comes from this group. The correct answer is highlighted.

T3A01

Why do VHF signal strengths sometimes vary greatly when the antenna is moved only a few feet?

  1. The signal path encounters different concentrations of water vapor
  2. VHF ionospheric propagation is very sensitive to path length
  3. Multipath propagation cancels or reinforces signals
  4. The Doppler effect causes slight frequency shifts which result in changes in signal strength

Correct answer: C. Multipath propagation cancels or reinforces signals

Why: VHF signals bounce off buildings and terrain and arrive by several paths. Depending on where your antenna sits, those copies add together or cancel out, so moving a few feet can change the signal a lot.

T3A02

How does vegetation affect UHF and microwave signals?

  1. Causes knife-edge diffraction, distorting voice peaks
  2. Absorbs signals, leading to poor reception of weak signals
  3. Amplifies signals, improving reception of weak signals
  4. Has no effect

Correct answer: B. Absorbs signals, leading to poor reception of weak signals

Why: Leaves and trees absorb UHF and microwave signals, which hurts weak-signal reception.

T3A03

What antenna polarization is normally used for long-distance CW and SSB contacts on the VHF and UHF bands?

  1. Right-hand circular
  2. Left-hand circular
  3. Horizontal
  4. Vertical

Correct answer: C. Horizontal

Why: Weak-signal CW and SSB work on VHF and UHF uses horizontal polarization by convention. FM and repeater work uses vertical.

T3A04

What is the effect of antenna cross-polarization over a line-of-sight VHF or UHF path?

  1. Modulation sidebands might become inverted
  2. Received signal strength is reduced
  3. Signals have an echo effect
  4. Nothing significant will happen

Correct answer: B. Received signal strength is reduced

Why: If one antenna is vertical and the other horizontal on a line-of-sight path, the received signal is much weaker. Match the polarization of the station you are talking to.

T3A05

When using a directional antenna, how might your station be able to communicate with a distant repeater if buildings or obstructions are blocking the direct line of sight path?

  1. Change from vertical to horizontal polarization
  2. Try to find a path that reflects signals to the repeater
  3. Try the long path
  4. Increase the antenna SWR

Correct answer: B. Try to find a path that reflects signals to the repeater

Why: With a directional antenna you can aim at a building or hillside and bounce your signal to the repeater when the direct path is blocked.

T3A06

What is the meaning of the term “picket fencing”?

  1. Alternating transmissions during a net operation
  2. Rapid flutter on mobile signals due to multipath propagation
  3. A type of ground system used with vertical antennas
  4. Interference from cable TV in the form of carriers at fixed intervals across the band

Correct answer: B. Rapid flutter on mobile signals due to multipath propagation

Why: Picket fencing is the rapid flutter you hear from a moving station as it drives through spots where multipath signals alternately reinforce and cancel.

T3A07

What weather condition might decrease range at microwave frequencies?

  1. High winds
  2. Low barometric pressure
  3. Precipitation
  4. Colder temperatures

Correct answer: C. Precipitation

Why: Rain and other precipitation absorb and scatter microwave signals, which shortens range.

T3A08

What is a likely cause of irregular fading of signals propagated by the ionosphere?

  1. Frequency shift due to Faraday rotation
  2. Interference from thunderstorms
  3. Intermodulation distortion
  4. Random combining of signals arriving via different paths

Correct answer: D. Random combining of signals arriving via different paths

Why: Signals reflected by the ionosphere arrive by several paths of slightly different length. They combine at random, which causes irregular fading.

T3A09

Which of the following results from the fact that signals propagated by the ionosphere are elliptically polarized?

  1. Digital modes are unusable
  2. Either vertically or horizontally polarized antennas may be used for transmission or reception
  3. FM voice is unusable
  4. Both the transmitting and receiving antennas must be of the same polarization

Correct answer: B. Either vertically or horizontally polarized antennas may be used for transmission or reception

Why: The ionosphere twists the polarization of signals passing through it. Because the result is elliptical, either a vertical or a horizontal antenna will work for skip signals.

T3A10

What effect does multi-path propagation have on data transmissions?

  1. Transmission rates must be increased by a factor equal to the number of separate paths observed
  2. Transmission rates must be decreased by a factor equal to the number of separate paths observed
  3. No significant changes will occur if the signals are transmitted using FM
  4. Error rates are likely to increase

Correct answer: D. Error rates are likely to increase

Why: Multipath makes copies of the signal arrive at slightly different times, which smears the data and raises the error rate.

T3A11

Which region of the atmosphere can reflect HF radio waves?

  1. The stratosphere
  2. The troposphere
  3. The ionosphere
  4. The electrosphere

Correct answer: C. The ionosphere

Why: The ionosphere, a layer of charged particles high in the atmosphere, can bend HF signals back to Earth. That is what makes long-distance HF contacts possible.

T3A12

What effect does fog or rain have on 10-meter and 6-meter band signals?

  1. Absorption
  2. Little effect
  3. Deflection
  4. Increased range

Correct answer: B. Little effect

Why: Fog and rain have little effect at 10 and 6 meters. Weather starts to matter at much higher frequencies, such as microwaves.

The other 2 groups in this section

These 23 questions are worth 2 of the 3 points this section carries on your exam.

T3B

Electromagnetic wave properties: wavelength vs frequency, nature and velocity of electromagnetic waves, relationship of wavelength and frequency; Electromagnetic Spectrum Definitions: UHF, VHF, HF

12 questions, in the full binder

T3C

Propagation modes: sporadic E, meteor scatter, auroral propagation, tropospheric ducting; F region skip; Line of sight and radio horizon

11 questions, in the full binder

The full Technician binder

Get the other 23 questions in T3, with explanations

  • All 409 official questions, every group in every section
  • A plain-English explanation under each answer
  • Unlimited full-length 35-question practice tests
  • A printable binder you can study from offline

Get the full binder

Keep going

See the Technician exam study guide for how the exam is scored, or try the free 10-question sample test.

Source: NCVEC Question Pool Committee, 2026 to 2030 Technician Class (Element 2) question pool, public release of February 19, 2026. Test Day Binder is not affiliated with the FCC, the NCVEC, or any volunteer examiner group.

Last checked: November 2026.

Leave a Comment